Timer T4
Options & Accessories
 Model 6070 Custom Carrying Case
Our Blow Molded Carrying Case with custom foam inserts can hold the Timer T4 console and a full compliment of five IR Sensors and five IR Emitters to protect them between events. The Carrying Case can also accomidate the printer, printer cable, roll of paper, and DC power cables. The best protection offered for the timing equipment is a foam filled custom carrying case fitted to the equipment. The case pictured above contains the Timer T4, five IR Emitters, five IR Sensors, and the 6038 Dot Matrix Printer.
 |
| Dot Matrix Printer |
| Finally! A battery powered printer! This 40-column Dot Matrix Serial Printer ships from RACEAMERICA with the battery power supplied from the timing system. No batteries required! The printer uses a standard 1/2" wide ribbon to produce clean, crisp characters on 4-1/2" wide continuous feed paper available at any office supply store. An external paper roll stand is included to accomodate larger rolls of paper. The printer offers a very compact size measuring 8"W x 8"D x 4"H. without the printer roll stand attached. |
 Model 6024 Intermediate ET Package
To add additional intermediate ET's to the Timer T4, order Model 6024. The Intermediate ET Package adds one of our race proven 5140C IR Track Sensors and one of the battery powered 5040A IR Beam Emitters. The Sensors plug into the existing pigtails on the Track Sensor Interconnect Cable shipped with the Timer T4. Up to three additional sets can be added to the base model of the Timer T4 providing three intermeditae track ET's and the final total ET.
 Model 7540 Sensor & Emitter Stands
Our IR Beam Emitters and IR Track Sensors are designed to be positioned flat on the road surface with the beam 1" off the race surface. If the racing surface has a severe crown or if your preference is to elevate the Emitter and Sensor to detect the body of the vehicle and protect the electronics, our new Foam Stands make it easy to set the beam at 6" off the race surface. These stands can be used for both Emitters and Sensors with easy assembly. For even more stability, weight can be added to the bottom of the stand or the stand can be attached to the racing surface. The straightforward design of these stands make them perfect for all types of racing events with easy setup and tear down.
 |
 |
Cable Reel Winders |
Cable Bucket Winders |
| The Model 6085 Cable Reel Winder handles all the Category 5 style cables up to 300 feet. Even wind multiple cables on the same winder. Perfect to insure setup and teardown are quick, easy, and cause no damage to the cables. |
The Model 6080 Cable Bucket Winder makes cable management a whole lot easier by eliminating tangles and knots. The unique features of the bucket allow both ends of the cable to be exposed so you can unwind just the right amount of cable for the particular setup or unwind all the cable and set the bucket aside. Each Bucket Winder will accomodate 660Õ of our heavy duty track cable.
|
|
