Page 1 of 1

How to change a hand controller button

PostPosted: Thu Jun 25, 2020 2:03 pm
by Dakimmer
I have both a wireless hand controller from one system and a hardwired hand controller from a friend's equipment. I see they both use the same hardware for the buttons which look universal so i assume the flag picture is something that gets inserted at the factory.

How would I change the button flag picture on one of the buttons?

Re: How to change a hand controller button

PostPosted: Sat Jun 27, 2020 8:41 am
by raceamerica
Dakimmer wrote:How would I change the button flag picture on one of the buttons?

The button and images are easily changed using a small flat blade screwdriver.

*** RIGHT CLICK THE LINK BELOW TO OPEN IN A NEW TAB ***

See video at https://www.youtube.com/watch?v=AcnXsWG_ctA

Re: How to change a hand controller button

PostPosted: Thu Jul 02, 2020 8:48 am
by Dakimmer
Can I buy just the button part that pops out with the screwdriver? I want to have the buttons preloaded so I can swap buttons and images quickly between race events where the flagman uses different flags with different race groups and the buttons are different for each of these groups.

Re: How to change a hand controller button

PostPosted: Mon Jul 06, 2020 1:30 pm
by raceamerica
Dakimmer wrote:Can I buy just the button part that pops out with the screwdriver?

Yes, part number 80-AL1W can be purchased direct from RaceAmerica. This item is not available through our Online Store.